questions questions and more questions

jamesthe1v

New Member
i am customizing a 2005 ezgo 36 volt. has f&r on rocker switch on dash and seems to have regenerative breaking therefore it'sa pds ..... i think . but i can not find a tow/maintenance switch anywhere??? does it have to have one? i was looking for one to do some tests on solonoid and controller because sometimes it wont click or move. after playing with it today i have decided if i turn on key and leave it on it will go all day . if i turn off and right back on it generally wont do anything??? if i wait a few min and turn on it's good to go??? also when it wont go if i put a small load (like just a test light) on the black wired side of solonoid itseems to go????? also red big wire has 36 volt black big wire doesnot and if you hold test light on black side you can watch it dim and go out??? any of this make any sence? as always any insight would be great thanks
dazed053.gif
dazed053.gif
dazed053.gif
dazed053.gif
dazed053.gif
wallbash.gif
wallbash.gif
wallbash.gif
 

jamesthe1v

New Member
1327495037782.jpg


1327495048167.jpg


also my 98 gas taxi

1327495169051.jpg


1327495282004.jpg


not having any luck getting them to automatically open :-( sorry
dazed053.gif



and here is next project if i get motivated, just finished maroon one so maybe save this noland 8 pass 36 volt duel rear axle (36 volt for each drive axle) (12 batt 72 volt total) for next winter haven't decided yet.
1323287013550.jpg
 

shadowman

New Member
thats the 1st time i have ever seen a duel axle cart before.......pretty cool.........i can,t help much other than to say if the cart has a run/tow switch it would be located right on the cover where controller is located......no switch there than there isn,t one.............................
cool.gif
 
Top