Precedent Camber

S

swag wagon

New Member
Hello new to the forum and have a 2012 Club Car Precedent with a Jake's lift on it. I checked the camber with a square up against the tires, and the passenger front is leaning in about 3/4" negative camber and the drivers side 1/4". I was wondering how to adjust camber?
 
On a stock 2012 you would loosen the 4 bolts labeled #1 and then loosen nut #26 then turn centric bolt #27 until the camber was equal on each side before tightening the four #1 bolts back down. Not sure how much stock is left after the jakes lift. Should have come with directions to set camber I would think.


1714431802726.webp
 
Thanks for the diagram I will try this as it still has the plate with the four bolts and the centric bolt. I will look on Jake's website also because I bought this cart 4 years ago with lift on it.
 
It will only make it even on both sides. I had a similar issue on my 08 DS and I lengthed both of the Delta A-plates 5/16". They call them A-arms on your cart. Strangely enough they don't seem to be numbered on the Precedent diagram but here they are.

1714433045167.webp
 
Notsoslim, how did you lengthen the Delta A Plates, dealing with the same problem with stock Precedent where I have the negative camber on both sides so moving the spring doesn't help.
 
stevei54 said:
Notsoslim, how did you lengthen the Delta A Plates, dealing with the same problem with stock Precedent where I have the negative camber on both sides so moving the spring doesn't help.
Click to expand...
See previous post

Notsoslim

Thread '20.5" Tires on a DS'

While I like the look of lifted carts I am hesitant to go to high with the center of gravity. My wife and grandkids drive the cart sometimes and I don't want them to get hurt. My wife drives like a maniac sometimes. I would like to step up to a good looking 20.5" tire and wheel combo. What is the minimum lift required to put this size tire on a 2008 DS? I see some of the aftermarket front springs come with 2 leafs instead of one and was wondering if that offers any lift at all. Maybe the 2 leaf and the 1" spacer block would do it. I am more than willing to learn from someone else's...




1731880529182.webp
 
You must log in or register to reply here.
Back
Top Bottom