Need some help!

newguyracing

New Member
What should I be seeing for voltage at the coil, when the fwd/rev switch is closed and the limit switch is open? Currently I am only seeing .76 volts at the coil but the cart is running. Does anyone know if this is correct?
 

shadowman

New Member
no you should be seeing at least battery voltage.........put cart in maintence mode ans than as long as your sure the battery is good and charged up get a volt meter and take reading from battery it should be approx 12 .7 or so and than start cart.........when you 1st start cart voltage will drop into the 11,s but will revover as you press gas pedal down so slowley press pedal down as you do voltage should rise until you get to WOT and voltage should be anywhere from 13. 7 to 15.3 approx .......anything lower or higher and voltage regulator is not working right................either not charging or over charging and frying battery........................................
cool.gif
 

newguyracing

New Member
Thanks for the information. It is greatly appreciated. Tracked problem down to a bad wire connection and is running much better.
 
Top