Headlight Switch Replacement Push Pull to Rocker Type

75Bigsky

New Member
Wanting to replace my headlight switch on 2013 EZGO TXT gas Kawasaki motor from a push pull type to a rocker type. Has anyone had any issues in replacing this what seems to be a simple two wire switch from a push pull to a rocker type switch? Any need to add relay or fuse since I'm just using the on/off part of a 5 pin switch? New replacement switch is 20 amp .
 

golfcar2000

Cartaholic
I plan on chasing circuit to see if it is fused, I would assume it has some overload protection as it is the factory circuit.
If it has a push/pull light switch it is probably not a factory installed light kit as the TXT cars came from the factory with a key switched lights. It had a [4] pole switch [rear] [3] position key switch off, run, and run/with lights. Most aftermarket/add on light kits used the push/pull switch.:twocents:
 
Top