Club Car Z lift

K

Kainalu

New Member
Has anyone found that after installing Jakes 4" Z lift that the front is now higher than the back by 1"-1 1/2" . It looks horrible. Any ideas to fix this would be nice
wallbash.gif
 
K

Kainalu

New Member
I would much rather do the block than 75 bucks. the fact that the u bolts have an inch and 1/4 left leaves me to think that block is out there somewhere
 
S

slim67

Active Member
Go to a spring shop and they can make what you want. They usually have spring steel for just about any auto,truck, trailer etc. They would likely make a 4inch higher version of what you have now.
 
K

Kainalu

New Member
another question with this lift. After installing a new engine snubber it seems that the severe angle cuts into the rubber. would flipping the snubber bracket over help this problem. It seems that it would help the angles a little more. Is there something else out there that anyone else uses in that area, I was thinking about just secureing a 1/2 inch thick piece of rubber on the aluminum angle

Thanks for all of the suggestions you guys have given lately
 
S

slim67

Active Member
I never liked seeing the engine tilted back like that after lifting a Club Car. My current cart has an extension bracket bolted to the original snubber bracket to drop the power frame thus leveling the engine. It worked like a charm and others here have done it.
thumbup.gif
 
K

Kainalu

New Member
Just an update on the snubber. I unbolted the bracket and flipped it over gained about two inches seems like this may fix the problem. The angle looks alot better. This should at least be in Jakes instructions on all their lifts.
 
You must log in or register to reply here.
Top