93 wiring problem

Steve

New Member
I too am new at this.

I picked up a 93 EZ-GO that I had to rebuild the battery boxes. In the process I took out the cotroler and the F/R switch, ah heck, I took out every thing. Am now trying to rewire. Any one got a wiring diagram of all the SMALL wires. the micro switches on the F/R switch, selinoid, kew switch, etc. I have the large (6 ga) wiring diagram and all that look OK.

Steve
 

Steve

New Member
Thanks so much. Since I posted last, I found the solenod to be bad, repalced and tunrs wheel both directions. Looks like F/R handel is backwards to direction but I guess that don't matter.

Another question....Those 3 resistor/capasitors, etc, are they nessceary? I've talked to three "cart" places and they don't seem to know WHAT they do, so they leave them off. I've only seen the two on the solenod for sale, except in a wholesale only web sit did I see the capasitor that goes between B+ and B- on the controler. Right now I don't have any of the three installed. cart is not quite ready, body, seats, etc. When I picked up this cart (junk) all three were there is the only reason I have to ask.

Steve
 

HotRodCarts

Cartaholic
As far as I know the resistor on the solenoid is for pre-charging the controller and the diode on the solenoid keeps voltage from back feeding through the system. I'm not sure about the capacitor on the controller. I would keep all three in place...
 
Top