87 36v Club Car Full Bore in Forward

[5150+]

87 36v Club Car cycles 5 solenoids in reverse, but goes straight to wfo in forward. Checked & swapped solenoids around, some new, all wires clean & in tact, what am I missing
Thanks in advance...

 

[Zman]

One of them is stuck on, I think it would be the end one on passenger side of cart.

 

[5150+]

I've changed them all around, 1st to last, middle to outters, & again, they all cycle perfect in reverse.
Stumped

 

[Golf Cart Wizard]

Is there a microswitch on the FNR? Check the wiring diagram section on this site and see if the wires are going to the right spots

 

[5150+]

By fnr you mean forward/reverse ? There is 1, seemed good, but even switched it out too.

 

[5150+]

Exploded the dia, + I most always snap a pic to refer back to. Is there another pack of micro switches I'm overlooking ?

 

[Golf Cart Wizard]

There are 5 micros in the speed switch but that would not be affected by shifting between forward and reverse. There must be a wiring problem somewhere, either the microswitch on the FNR is back feeding your solenoids or the high current cables going into it are connected to the wrong locations

 

[Golf Cart Wizard]

 

[5150+]

Problem solved...
Was moving around a "new" junk solenoid from, you can guess where...
Thanks for the feed back.