jhabisch2000
New Member
The Cart ran fine and then stopped working after the kids were driving it for most of the day. I have been all over checking the forums and running test. Here is what I know:
36 volt – Batteries are charged!
F/R switch is under leg
When I press the go pedal, I the solenoid clicks (just once not all the time) but the golf cart won't run.
The micro switch under floor mat has continuity.
ITS micro switch – checked out ok!
Reverse buzzer works – After bypassed bad reed switch!
I have jumped the solenoid by using a 6 ga wire and connecting ONLY the two large terminals – Nothing happens.
I have jumped B- and M- and nothing happens!
Motor Turns - I have completed the motor test - Put a jumper wire from a "A" terminal to an "S" terminal. (Example: A1 to S1)...Then touched the A2 and S2 to the 36volt batteries. It turned not real fast.
After motor test, hooked everything up, with by passed reed switch, step on go pedal and everything was fine. Lowered cart and drove about 50 feet and it died again! Rechecked everything…including Motor test….all check out. Any Ideas.
36 volt – Batteries are charged!
F/R switch is under leg
When I press the go pedal, I the solenoid clicks (just once not all the time) but the golf cart won't run.
The micro switch under floor mat has continuity.
ITS micro switch – checked out ok!
Reverse buzzer works – After bypassed bad reed switch!
I have jumped the solenoid by using a 6 ga wire and connecting ONLY the two large terminals – Nothing happens.
I have jumped B- and M- and nothing happens!
Motor Turns - I have completed the motor test - Put a jumper wire from a "A" terminal to an "S" terminal. (Example: A1 to S1)...Then touched the A2 and S2 to the 36volt batteries. It turned not real fast.
After motor test, hooked everything up, with by passed reed switch, step on go pedal and everything was fine. Lowered cart and drove about 50 feet and it died again! Rechecked everything…including Motor test….all check out. Any Ideas.