Just replaced the batteries and the wires were hooked up by the old owner wrong,first it blew the module box between the batteries,Had an old module box and swapped it out.Now when you turn the key it takes off wide open...Anyone I need help...Thanks
Change the wire to m-1 to switch,and nothing happen,then turned the back tire then hit the pedal and there it went..Wires getting hot,I guess I need to up grade to 4 gage..
Thanks...
Which cable(s) are getting hot? Make sure all the cables have clean tight connections. Seeing how you had to spin a tire to get the motor to turn it could be bad/worn brushes causing the cables to get hoe
Mostly the cables going to the F/R switch are getting hot,will change them out to 4 gage. Also the cart will not move after putting it in reverse, then switching back to forward..
Thanks for your reply.
Cool,I will try to clean the contacts on the F/R switch, Also the cart came with a charger , I want to get it checked out before attempting to charge the batteries. Not sure if I have the wires connected right to try it...Thanks again for your help....
This site is great, I found the wiring diagram and that had the location of the charger wires. Will check them out again before I charge it. Next will be looking to lift and paint it. Thanks again...
I am really surprize for a 1990 ez go that only cost me 250.. plus new batteries works really well. Even came with a charger and thats worth 250.00 by itself...lol Ready to lift up !!!!