1988 club car

[BCGC]

couple questions don't know if anyone can help. looking for screw and bolt sizes.
1- the small philips head that holds the f and r handel on
2- the 3 large philips screws and nuts that fasten the f and r to the cart body
3- the screws that hold the alum trim above the dash below the windshiel around club box?
sorry to ask but thought they would come with the new parts.

 

[JRay]

Local CC dealer should be able to fix you right up. they will have what you need.

 

[JRay]

That way you get the right stuff.

 

[Andy4639]

If you have any of them take them to lowes and they have a thread gauge in the hardware area to see what size they are.
The ones that hold the F/R to the body is 1/4 -20 I think but as stated LOWES would be the best and cheaper than a dealer.

 

[JRay]

Well the only problem is the correct length, unless you want to cut them. Most CC stuff is 2-3/4, all the hardwares, lowes etc. only carry 3in, all there nuts and bolts are in 1/2 in. increments. i like my carts with the oem stuff on them, not a bunch of cobbled up parts on them. Stainless is the way to go.

 

[dougmcp]

I guess you answered your own question.
If you will only accept factory parts then your only option is go to the dealer.

 

[JRay]

I didn't ask the question. I offered my opinion like everyone else does around here.

 

[dougmcp]

Sorry, I thought you were the OP, my mistake.

 

[golfdog]

I have a 2001 CC and the switch bolt sizes are as follows

Handle Phillips head machine #8 - 32 x 5/8

Mounting 3 x Phillips Truss Head 1/4 - 20 x 2 1/8

The sizes for the trim mounting screws are not quoted in the parts manual.

Hope it helps.

 

[HotRodCarts]

Thank you golfdog.

 

[Andy4639]

Lowes sell metric stuff and cutting is no problem if done right.
S/S you can get at a local hardware store.

 

[BCGC]

thanks for your time. info was very helpful